Lancom 7111 VPN Manual page 21

Flashing Power LED but no connection?
There's no need to worry if the Power LED blinks red and you can no
longer connect to the WAN. This simply indicates that a preset time or
connect-charge limit has been reached. There are three methods
available for unlocking:
Reset connect charge protection.
Increase the limit that has been reached.
Completely deactivate the lock that has been triggered (set limit
to '0').
If a time or connect charge limit has been reached, you will be notified in LANmonitor. To
reset the connect charge protection, select Reset Charge and Time Limits in the context
menu (right mouse click). You can configure the connect charge settings in LANconfig under
Management Costs (you will only be able to access this configuration if 'Complete con-
figuration display' is selected under View
You will find the connect charge protection reset in WEBconfig and all parameters under
Expert Configuration
VPN VPN connection status
off
green
green
green
green
Security Status of the Firewall. Shows the state of security settings and blocked attacks
on the secured network.
green
red/
green
red
Options...).
Setup Charges-module.
No VPN channel established
blinking Connection established
flashing First connection
inverse flashing Further connections
constantly on VPN channel is established
constantly on Security settings are okay. Rules for filtering packets are
established
blinking Insecure configuration
flickering Security alarm: filtering packets with Firewall rules
LANCOM 7111 VPN – LANCOM 8011 VPN
Chapter 2: Installation
LANCOM
Systems
Signal for reached time
or connect-charge
limit
21