Minolta PagePro 1200 Series Service Manual page 78

PagePro 1200 Series Maintenance / Disassembly
7. Remove the lamp holder (two screws).
8. Pull out the Heater Lamp.
NOTES
• Use care not to touch the lamp surface with bare hands.
• Position the voltage mark on the gear side when reinstalling the lamp.
Heater Lamp
9. Remove the drive gear from the Heat Roller.
10. Slide the Heat Roller to the right (a), swing out the left end (b), and then slide the roller in the
direction of (c) and pull it out.
NOTE
• To prevent the surface of the Heat Roller from being scratched by the Fusing Separators, lift the
separators when removing and reinstalling the roller. Use utmost care not to damage the surface
of the roller.
(b)
(c)
Voltage Mark
(a)
78
4127s049
4127s050