Minolta PagePro 1200 Series Service Manual page 56

PagePro 1200 Series Mechanical / Electrical
At 600 dpi
The printer is initialized upon power supply. The printer then starts warming up and the Heater
Lamp turns on. The temperature is controlled as follows.
Mode 1
The temperature is controlled to maintain 125
°
ing standby and 200 C during printing. If this mode continues for 300 seconds (PagePro 1250E) or
90 seconds (PagePro 1200W), the control will shift to mode 2.
Mode 2
The temperature of the Heat Roller falls gradually to about 190
If this mode continues for 208 seconds, the control will shift to mode 3.
Mode 3
The temperature is controlled to maintain 125
°
ing standby and 190 C during printing. Unless an error occurs or the control is opened, this mode is
maintained.
At 1200 dpi
When the printer completes the initialization sequence after it has been turned ON, it starts warming
up and the Heater Lamp turns ON. The Heater Lamp remains ON until the temperature of the Heat
°
Roller becomes about 160 C, providing the following temperature control.
Mode 1
The temperature is controlled to maintain about 160
°
1250E) or 115 C (PagePro 1200W) during standby. This mode lasts 300 seconds (PagePro 1250E)
or 90 seconds (PagePro 1200W) seconds before the control shifts to mode 2.
Mode 2
This mode lasts for 208 seconds before the control shifts to mode 3.
The temperature of the Heat Roller gradually falls from about 160
Mode 3
The temperature is controlled to maintain at about 155
°
(PagePro 1250E) or 115 C (PagePro 1200W) during standby. This mode is maintained unless an
error occurs or the Top Cover is opened.
° °
C (PagePro 1250E) or 115 C (PagePro 1200W) dur-
°
C from about 200
° °
C (PagePro 1250E) or 115 C (PagePro 1200W) dur-
°
C during printing and about 125
°
C to about 155
°
C during printing and at about 125
56
°
C.
°
C (PagePro
°
C.
°
C