Minolta PagePro 1200 Series Service Manual page 38

PagePro 1200 Series General Information
(4) To Reset the Counter of the Toner Cartridge
Perform the following procedure to reset the toner cartridge counter after you replace the toner car-
tridge.
1. Turn off the printer.
2. While holding down the panel button, turn on the printer.
" "
The green Ready indicator begins to blink.
3. Keep the panel button held down, and the
" "
Ready indicator has blinked for about 5 seconds, release the panel button.
All two indicators begin to blink.
4. After confirming that all the indicators are blinking, press and hold down the panel button again
for at least 5 seconds.
Both indicators light up for about 5 seconds, and then the two indicators begin to blink.
The counter for the toner cartridge has now been reset.
5. Turn the printer off and then on again.
" "
Once the green Ready indicator remains on permanently, the printer is again in Standby
mode.
(5) To Reset the Counter of the Drum Cartridge
Perform the following procedure to reset the drum cartridge counter after you replace the drum car-
tridge.
1. Turn off the printer.
2. While holding down the panel button, turn on the printer.
" "
The green Ready indicator begins to blink.
3. Keep the panel button held down, and the
" "
Ready indicator has blinked for about 5 seconds, release the panel button.
All two indicators begin to blink.
4. After confirming that all the indicators are blinking, briefly press the panel button.
Both indicators light up for about 5 seconds, and then the two indicators begin to blink.
The counter for the drum cartridge drum cartridge has now been reset.
5. Turn the printer off and then on again.
" "
Once the green Ready indicator remains on permanently, the printer is again in Standby
mode.
" "
Ready indicator will start to blink. After the
" "
Ready indicator will start to blink. After the
38