Minolta PagePro 1200 Series Service Manual page 37

(3) Control Panel Button Function
The panel button is used to perform the various operations as detailed below according to the status
of the printer:
• reset the counter
• cancel a print job
• print out the configuration page (PagePro 1250E only)
• continue a print job after an error message
• reset the printer (PagePro 1250E only)
•
Function Explanation
Use the following procedure whenever you want to reset the counter.
1.
2.
3.
Reset the counter
After all the indicators blink, the printer enters the counter reset mode.
Refer to P.32.
Use the following procedure whenever you want to cancel the current job.
1.
Job Cancel
2.
Use the following procedure whenever you want to configuration for printer.
1.
• the orange "Error" indicator is off, and
2.
Print Configuration
3.
Page
• If the Panel button is pressed two more times, the configuration page is
• If the Panel button is pressed three more times, the PCL font list is printed.
• If the Panel button is pressed four more times, the PS font list is printed.
Continue the print job after correcting the following types of errors:
• when the print job is too complex and the memory capacity of the printer is
• when there is no more paper in the feed trays
Continue a print job
• when paper of a different format to that set in the printer driver was fed into
after an error message
1.
2.
Initialize the settings to factory default.
1.
2.
Reset the printer
3.
4.
Turn off the printer.
While holding down the Panel button, turn on the printer.
The green "Ready" indicator begins to blink.
Keep the Panel button held down, and the "Ready" indicator will start to
blink. After the "Ready" indicator has blinked for about 5 seconds, release
the Panel button.
All two indicators begin to blink.
While data is being processed or printed (When the green "Ready" indicator
is blinking), hold down the Panel button for more than 5 seconds.
Release the Panel button after both indicators light up.
The current print job has now been cancelled.
Make sure that:
the green "Ready" indicator is on (but not blinking).
Briefly press the panel button.
All indicators blink rapidly.
Press the Panel button.
The page that is printed depends on the number of times that the Panel but-
ton is pressed.
printed.
inadequate
the printer
Check that one of the above errors has occurred.
Press the panel button in order to operate the page feed.
The print job continues.
Turn OFF the Power Switch.
Open the Top Cover and, holding down the panel button, turn ON the Power
switch.
Keep pressing the panel button for 20 sec. or more. (The two LED indica-
tors flash off and on at a slow pace and then only the Error indicator lights
up steadily.)
Release the panel button and close the Top Cover.
37
PagePro 1200 Series General Information