Adapting To Individual Requirements; Tips For The Automatic Programmes - Siemens HB78GB.90B Instruction Manual

Select the programme group by turning the rotary selector.
2.
3URJUDPPHV
¿
Press the button and select the programme with the rotary
3.
selector.
3URJUDPPH
In some of the programmes, you can make further
4.
specifications, e. g. Joint of veal option, followed by Lean joint
or Marbled joint. Press the button
using the rotary selector.
3URJUDPPHV
¿
Press the button.
5.
A suggested weight appears for the programme selected.
6. Turn the rotary selector to set the weight. The programme
length is displayed in the status bar.
3URJUDPPHV

Tips for the automatic programmes

The weight of the joint or poultry is
greater than the weight ranges availa-
ble.
The joint has cooked well, but the juices
are too dark.
The joint has cooked well, but the juices
are too clear and watery.
The joint is too dry on the top.
The joint looks good, but there was a
burning smell during roasting.
You wish to prepare frozen meat.
The meat is not cooked well enough or
is too well cooked.
26
¿
and make your selection
The weight range is deliberately limited. For very large joints, it is often impossible to
obtain a sufficiently large roasting dish. Prepare large pieces with
4
or Hot air grilling.
Select a smaller dish or use more liquid.
Select a larger dish or use less liquid.
Use a dish with a tightly fitting lid. Very lean meat will remain more succulent if it is cov-
ered with rashers of bacon.
The lid of the roasting dish is not closed properly, or the meat has expanded and has
pushed up the lid. Always use the right lid for your ovenware. Make sure that there is at
least 3 cm between the meat and the lid.
Season frozen meat in the same way as fresh meat. Caution: For frozen meat it is not
possible to delay the end time. The meat would defrost during the waiting time and would
be inedible.
Change the settings the next time. You will find information on this in the Automatic pro-
grammes, Individual Settings section.
¿
Now if you press the button again, you can switch to Adjust
programme individually. You can influence the result of the
programme. See Adjust programme individually below.
†
7. Press the button.
The programme starts. You can see the cooking time
counting down in the status bar.
The programme has ended
A signal sounds. The oven stops heating. You can cancel the
signal earlier by pressing the
Cancelling the programme
†
Press and hold button until 3D hot air, 160 °C appears. You
can make new settings.
Calling up information
Before starting: Press the button
±
on the programmes is displayed. For each item of information,
press the button again briefly.
Setting a later end time
With many of the programmes, you can set a later end time.
See the Time-setting options section.

Adapting to individual requirements

If the cooking result of a particular programme does not meet
your expectations, you can adapt it to your requirements the
next time.
¿
Adjust the settings as described in points 1 to 6.
Press the button and move the illuminated field using the
ÙÙÙØÙÙÙ
rotary selector.
To the left = weaker cooking result.
To the right = cooking result more well done.
†
Start with the button.
The cooking time for the programme changes.
0
button.
±
briefly. Various information
%
Top/bottom heating
x