Control Buttons; Installing The Air Filters - Respironics SleepEasy User Manual

Control Buttons

Heated Humidifier (HEAT) Button
These buttons are described below.
b
utton
Starts the airflow and places the device into Active state, or stops the airflow, and places the device into
Standby state. It is also used to exit any display screen.
Controls the humidifier functions.
When the airflow is on, this button allows you to activate or restart the ramp function. Ramp lowers the
airflow pressure and then gradually increases it, allowing you to fall asleep more easily.
Controls the C-Flex functions. This allows you to adjust the level of air pressure relief that you feel when you exhale
during therapy.
+ Performs next screen navigation or increases setting.
- Performs previous screen navigation or decreases setting.
The START/STOP, HEAT, RAMP and FLEX buttons are lit by LED backlights. The START/STOP LED will always be
on when power is applied to the device. The HEAT LED is on when the humidifier heater plate is active, and off when
it is not. The RAMP LED is on when the ramp function is active and off when it is not. The HEAT, RAMP and FLEX
LEDs will flash when their respective settings are being adjusted.

Installing the Air Filters

CAUTION: A properly installed, undamaged reusable gray foam filter is required for proper operation.
The device uses a gray foam filter that is washable and reusable, and an optional white ultra-fine filter that is disposable.
The reusable filter screens out normal household dust and pollens, while the optional ultra-fine filter provides more
complete filtration of very fine particles. The gray reusable filter must be in place at all times when the device is
operating. The ultra-fine filter is recommended for people who are sensitive to tobacco smoke or other small particles.
A reusable gray foam filter and a disposable ultra-fine filter are supplied with the device. If your filters are not already
installed when you receive your device, you must at least install the reusable gray foam filter before using the device.
To install the filter(s):
1. If you are using the white disposable ultra-fine filter, insert it into the filter area first, mesh-side facing in, towards the device.
2. Insert the gray foam filter into the filter area after the ultra-fine filter.
Note: If you are not using the white disposable filter, simply insert the gray foam filter into the filter area.
6
Display Screen
Flex Button
User Buttons
Start/Stop Button
Ramp Button
D
eScription
U M
ser anUal