Deletion of blocks
This item is password protected.
The delete function is used to clear all data (settings) from an
adjustment block.
A delete can be given :
- block by block
or
- for all blocks.
Deleting block by block
The delete a block function deletes the settings of a selected block.
Highlight 'Delete a block' with the control disk and press ENTER .
Push the control disk up or down to select the desired adjustment
block. Press ENTER to delete the selected adjustment block. A
confirmation menu will be displayed.
ENTER will delete the selected block.
EXIT cancels the deletion procedure and returns to the Service mode
main menu.
Deletion of all blocks
Highlight 'delete all blocks' with the control disk and press ENTER .
ENTER gives a confirmation message before deleting.
If you are certain you wish to delete all blocks, press ENTER to
confirm, otherwise press EXIT to return.
Once ENTER is pressed, all block headers and adjustment settings
are permanently removed and cannot be restored.
5975628 BARCOGRAPHICS 1209s 010797
SERVICE MODE
IDENTIFICATION
COPY A BLOCK
DELETE A BLOCK
DELETE ALL BLOCKS
CHANGE PASSWORD
CHANGE LANGUAGE
RUN TIME
SET TO MIDPOSITION
CONVERGENCE MID
DYNAMIC ASTIGMATISM
MORE...
Select with
or
then <ENTER>
<EXIT> to return.
DELETE MODE
Nr. Src Fh
Fv
inp
conf
1
1
15.6 50
video
FC
2
3
31.2 60
RGB3S RT
3
-
15.6 50
intern
FC
4
2
31.5 50
RGB3S FC
5
-
33.7 60
intern
FC
6
7
8
Active block nr. 1
Select with
or
<ENTER> to copy
<EXIT> to return.
DELETE BLOCK
The selected block
will be deleted !
<ENTER> to confirm
<EXIT> to cancel
SERVICE MODE
IDENTIFICATION
COPY A BLOCK
DELETE A BLOCK
DELETE ALL BLOCKS
CHANGE PASSWORD
CHANGE LANGUAGE
RUN TIME
SET TO MIDPOSITION
CONVERGENCE MID
DYNAMIC ASTIGMATISM
MORE...
Select with
or
then <ENTER>
<EXIT> to return.
DELETE BLOCK
All block
will be deleted !
<ENTER> to confirm
<EXIT> to cancel
Service Mode
7-3