Table of Contents
Advertisement
Connections
The way of starting up can be set in the service mode.
Start up with full white image.
The next menu will be displayed for 30 seconds.
a. Start up with warm up period.
If no action is taken, a white image will be displayed for 20 minutes.
This white image will be shifted on the faceplate of the CRT to avoid a CRT burn in.
During this warm up period, it is possible to interrupt this white image projection by
pressing the EXIT key. The previous menu will be repeated for another 30 seconds but
the remaining time will be indicated.
If EXIT is pressed, the remaining warm up period will be shipped.
During the warm up period, every 30 seconds a text box with the remaining time will be
displayed on the screen for 2 seconds. This text box will be displayed every time on
another place.
If another key, different from EXIT, is pressed, a text box with following text will be
displayed :
Please use <EXIT> to leave this procedure.
b. Start up without warm up period.
If the EXIT key is pressed, the warm up period will be skipped and the projector is
immediately ready for use.
Warning : skipping this warm up procedure can reduce the initial picture quality
of the projected image.
Signal Input Connection to the Projector :
- Composite Video
- S-Video
- RGBS or RGsB
- RGB3S or RG3sB (option)
- Component Video
Port No
Projector input
1
Comp. Video
2
S-Video
1
2
3
RGB
4/5
RGB
2
4/5
Component video
4/5
RGB with Tri level sync
4/5
Component video
with Tri-level sync
Only available when the optional Tri-level sync module is installed.
3-2
Press Digit Button
/Comp. Video*
3
4
5
Comp/H sync V sync
PORT 6
REMOTE
PORT 3
COMMUNICATION
R
3
1
2
3
1
2
4 or 5
6
3
7
4
5
8
*
PROJECTOR WARM UP
A FULL WHITE PATTERN
WILL BE GENERATED FOR
20 MINUTES.
FOR IMMEDIATE USE OF
THE PROJECTOR, PRESS
WARNING : SKIPPING THIS
PROCEDURE CAN REDUCE
THE INITIAL PICTURE
QUALITY OF THE PROJECTED
THIS OPTION CAN BE
DISABLED IN THE SERVICE
PORT 4/5
PORT 1
PROJECTOR MODE
(VIDEO)
(RGB - HV)
GREEN : operational
RED : stand-by
OFF ON
75 ohm
G
B
4
1
5
Input signal Y/C (luma/chroma)
Input signal : R, G and B with automatic sync
detection between seperate sync (separate com-
posite sync or with separate Hor and Vert. sync)
or sync on green (composite sync).
Input signal : R-Y, Y and B-Y with separate
composite sync or with separate Hor and Vert.
sync or with composite sync on Y.
Input signal : R, G and B with separate Tri level
sync or with Tri-level sync on green.
Input signal : R-Y, Y and B-Y with separate Tri
level sync or with composite Tri-level sync.
Video or S-Video : switchable in the Picture
Tuning menu.
5975628 BARCOGRAPHICS 1209S 010797
<EXIT>.
IMAGE.
MENU
REMAINING
PROJECTOR
WARM UP
TIME
18.5MIN
PLEASE USE
<EXIT> TO
LEAVE THIS
PROCEDURE
POWER/MAINS
PORT 2
(S-VIDEO)
OFF
ON
75 ohm
357
2
Advertisement
Table of Contents
