Table of Contents
Advertisement
3
CONNECTIONS
AC Power (mains) Cord Connection
Use the supplied power cord to connect your projector
to the wall outlet. Plug the female power connector into
the male connector at the frontside of the projector.
Power Check
Power voltage indication on sticker on the rear side of the projector.
The power voltage is indicated by the art. no.
Warning !
Check if the indicated power voltage corresponds to that of the wall
outlet.
Art. No. R9000972 must be connected to a 230 VAC power source.
Art. No. R9000977 must be connected to a 120 VAC power source.
If the wall outlet voltage is different, call a qualified technician for
power adaptation of the projector.
Switching On/Off
The projector is switched ON and OFF using the power (mains) switch
ON/OFF.
Pressed : ON
Not pressed : OFF
The projector can start now in the 'operational mode' (image dis-
played) or in the 'stand by mode', depending on the position of the
'power up' dip switch on the controller unit. This DIP switch must be
set during installation by a qualified technician. If you want to change
this start up mode, call a qualified technician.
Stand by indication lamp :
no light up : projector switched off
green color : projector in Operational mode
red color : projector is in Standby mode.
When starting up the projector, with the power switch or via the stand-
by key, the projector can start up in two ways if the "CRT run in" cycle
option is switched OFF.
- full white image (projector warm up) or
- immediately image display.
5975628 BARCOGRAPHICS 1209S 010797
V NOM
120/230 Volt
I MAX
7/5Amp
FREQ
50/60Hz
IN
RS232
OUT
RS232
IR
RS232 IN
RS232 OUT
IR
REMOTE
REMOTE
T 1
PROJECTOR MODE
EO)
GREEN : operational
RED : stand-by
PORT 2
(S-VIDEO)
OFF
ON
ON
75 ohm
hm
Connections
685
POWER/MAINS
352
3-1
Advertisement
Table of Contents
