Table of Contents
Advertisement
2
LOCATION AND FUNCTION OF CONTROLS
REAR PANEL TERMINOLOGY
PORT 6
REMOTE
PORT 3
COMMUNICATION
1
2
Communication Port (800 peripherals)
1
* allows communication between the RCVDS switcher and
the projector.
* allows connection of a remote IR receiver unit to the
projector.
Port 3
2
RGB Analog Input (9 pin female sub D connector). Allows
a character generator, microcomputer, etc. having analog
RGB outputs to be connected to the projector.
Port 4/5 : RGB-S Input (5x BNC connector):
3
RGB-S input : allows a character generator, microcomputer,
video camera, etc. having analog RGB output to be con-
nected to the projector.
Line inputs:
- signals RED-GREEN-BLUE
- COMPOSITE sync. signal
- Tri level sync signal (option)
VIDEO Input (Composite video, 2x loop-through BNC
4
connector): allows a video tape recorder, video camera,
color receiver/monitor, etc. having video line output to be
connected to the projector.
75 ohm Termination Switch for Video signals
FRONT PANEL TERMINOLOGY
V NOM
120/230 Volt
I MAX
7/5Amp
50/60Hz
FREQ
5
RS 232 Input Port
1
Connection between the projector and an IBM PC (or
compatible) or MAC (RS422) for remote computer control
and data communication.
RS 232 Output Port
2
RS 232 Input Port allows a communication link for PC or
MAC to the next projector in a series of projector.
5975628 BARCOGRAPHICS 1209S 010797
PORT 1
PORT 4/5
(RGB - HV)
(VIDEO)
Comp/H sync V sync
OFF ON
75 ohm
R
G
B
3
4
IN
RS232
OUT
RS232
IR
REMOTE
RS232 IN
RS232 OUT
REMOTE
IR
1
2
3
4
PROJECTOR MODE
POWER/MAINS
GREEN : operational
RED : stand-by
PORT 2
(S-VIDEO)
OFF
ON
75 ohm
5
6
7
Projector Pilot Lamp : indicates the status of the projector.
5
- unlit : mains (power) switch is not pressed.
- lit : mains (power) switch is pressed and the indicated color
shows the projector mode:
Green color : operational mode of the projector.
Red color : standby mode of the projector.
Important : projector ("Operational" or "Standby") mode is
defined during the installation of the projector. (Refer to a
qualified technician for change).
S-VIDEO Input: S-Video or Video in, depending on the
6
priority setting in the Picture Tuning menu.
For S-Video : Separated Y/C (luma-chroma) signal inputs
and outputs for higher quality playback of Super VHS signals
(4-pin S-VIDEO connector loop-through).
75 ohm Termination Switch for S-Video signals
For Video : Composite video inputs on pin 1 and 3.
Power Switch : press the switch to turn the projector ON.
7
Depending on the hardware set-up of the projector during
installation, the projector switches to 'Standby' or to 'Op-
erational' mode. If in standby, the standby LED lights up.
685
IR Sensor
3
receiver for control signals transmitted from the RCU.
IR Remote
4
Connector for remote input for hard wired remote control
5
AC Power input
Location and Function of Controls
2-1
Advertisement
Table of Contents
