Lexmark MS610dn Manual page 46

Printer specifications
Print material
Integrated forms
1
Paper less than 75 g/m
2
See "Grain orientation" on page 17
3
Vinyl labels are supported only when printing environment and media are 20–32°C (68–90°F).
4
Pressure‑sensitive area must enter the printer first.
For paper and transparency specifications, see the Lexmark C750 Publications CD.
The following table indicates the paper sizes each tray supports.
Source
Standard tray 148 x 210 mm
500‑sheet drawer (5.83 x 8.27 in.)
Multipurpose 148 x 210 mm
feeder* (5.83 x 8.27 in.)
* If you load paper that is narrower than 148 mm (5.83 in.) in the multipurpose feeder (for example, 3 x 5‑inch index cards),
set the MP Feeder Size menu item to Universal.
Labels Thickness:
Smoothness:
* 150–250 Sheffield is optimal. Using media higher than 300 Sheffield could result in printing degradation.
Card stock and label guidelines
Labels are one of the most difficult print materials for laser printers. A fuser equipped with a web oiler may be required
for label applications to optimize feed reliability. Contact your local service representative for ordering information.
If you print large quantities of labels or other glossy print media, replace the fuser housing with a web oiler field upgrade
kit (P/N 12G6307 for a 115 V printer, P/N 12G6308 for a 220 V printer).
When printing on labels:
• Using the printer operator panel, set the Paper Type to Labels in the Paper Menu. For vinyl and other heavy labels,
set the Labels Weight (under the Paper Weight menu) to Heavy, and set the Labels Texture (under the Paper Texture
menu) to Smooth.
• Do not load labels together with paper or transparencies in the same paper tray. Combining print materials can
cause feeding problems.
•
Use full label sheets. Partial sheets may cause labels to peel off during printing, resulting in a paper jam. Adhesive
material may contaminate your printer. It could also void your printer and cartridge warranties.
When feeding labels, the number of labels per sheet can affect registration more than basis weight. Typically, the more
labels per sheet, the better the registration.
4
Pressure‑sensitive area
Paper base (grain long)
2
is supported only when the relative humidity is less than 60% and is not supported in duplex.
for specific recommendations.
Standard sizes
(width x length)
Minimum
215.9 x 355.6 mm
(8.5 x 14 in.)
215.9 x 355.6 mm
(8.5 x 14 in.)
0.102–0.305 mm (0.004–0.012 in.)
100–400* Sheffield
Range or maximum weight supported
500‑sheet tray and optional
500‑sheet drawer
2
140–175 g/m
2
75–135 g/m
(20–36 lb bond)
Maximum
139.7 x 210 mm
(5.5 x 8.27 in.)
69.85 x 127 mm
(2.75 in. x 5 in.)
Multipurpose feeder
2
140–175 g/m
2
75–135 g/m
(20–36 lb bond)
Universal sizes
(width x length)
Minimum
215.9 x 355.6 mm
(8.5 in. x 14 in.)
229 x 355.6 mm
(9.01 x 14 in.)
46
Maximum