Lexmark MS610dn Manual page 15

General information
Problem
Print on heavy stock is
blurred or out of focus.
Toner rubs off the page.
Printing shows voids.
Solution
Make sure the Paper Type setting is correct for your print material.
Note: Card stock in excess of 203 g/m
results.
Print on five sheets of paper, wait for approximately five seconds, and then print five more
sheets of paper to remove any toner that may have accumulated.
Make sure the Paper Type setting is correct for your print material.
Use material that is lighter than 300 g/m
Print on five sheets of paper, wait for approximately five seconds, and then print five more
sheets of paper to remove any toner that may have accumulated.
Change the Paper Type to Plain Paper.
Print on five sheets of paper, wait for approximately five seconds, and then print five more
sheets of paper to remove any toner that may have accumulated.
2
(54‑lb bond) may not produce acceptable print
2
.
15