• Install the 90 elbow onto the water inlet.
Step 3
Install
• The 90 elbow should face the left or right
Water Inlet
Fittings
• Install strain relief onto junction box and
Step 4
Install
• Strip 1/2" insulation from end of power
power cord
• Connect incoming wires to dishwasher wires
(If used)
• Connect the white to white, black to black
Skip this step
If dishwasher
• Push all wires into the junction box and
will be wired
direct.
Note: The power cord and connections must
comply with the National Electrical Code,
Section 422 and/or local codes and
ordinances.
IMPORTANT: The power cord must be no
longer than 6 ft from the junction box to the
plug. DO NOT PLUG IN POWER CORD AT
THIS TIME.
Use thread sealing tape or pipe thread
compound.
side, depending on water line routing.
tighten against incoming wires.
cord wires.
using wire nuts of appropriate size.
and incoming ground to green wire.
secure cover with screws onto dishwasher
frame.
Installation
Stainless Steel Interior Dishwasher
Screw F
11