EverFocus PowerPlex EDR1600 Administrator's Manual And Operating Instructions page 29

n Output – Alarm Out output state when the hard disk capacity is full.
n Buzzer On – To activate the internal buzzer or not when the full hard
disk capacity is detected.
n Log – Activates the event log list. Please refer to Log Display for
the details.
n Show Message – Displays the alarm message when the full hard disk
capacity is detected.
n Send Mail – Check to activate the e- mail notification function. There
will be an e- mail notification sent to the defined receivers while the
hard disk capacity is less than 10%. Please refer to Chapter 6.15 for
e-mail notification setting.
Note. If the hard disk capacity reaches the end with the Auto Overwrite function not
enabled while the user login in as an Operator, the system will show a message
to ask the user to login as an Administrator or Supervisor for the further
procedures.
For NC signal, it's always open, for NO signal close. The Normal
State above shows whether the selected Alarm Out is NC signal or
NO signal.
Administrator's Guide and Operating Instructions
26