Status Tab - HP StoreOnce User Manual

2. Locate its VIF IP in the System Information.
To identify the VIF address from the StoreOnce CLI (command line interface)
Use the net show config command and locate the Node Specific Parameters.
You are looking for the Network Virtual Data IP entries under each node. (The network
template that was applied at system installation determines whether it is a 10GbE or 1GbE network.)
The following example is an extract from the output of the net show config command.
# net show config
External Network Configuration
------------------------------
Template 1
Management on (2) 1Gb ports (bonded), Data/Replication on (2) 10Gb ports (bonded)
Virtual Management Console IP Address: 16.26.xxx.xxx
Node Specific Parameters
------------------------
Node 1:
1GbE Network Physical IP (HP Service Only): 16.26.xxx.xxx
10GbE Network Physical IP (HP Service Only): 172.16.7.199
10GbE Network Virtual Data IP: 172.16.7.200
Node 2:
1GbE Network Physical IP (HP Service Only): 16.26.xxx.xxx
10GbE Network Physical IP (HP Service Only): 172.16.7.201
10GbE Network Virtual Data IP: 172.16.7.202

Status tab

Status tab 43