Bandwidth Limiting Tab - HP StoreOnce User Manual

Table 14 General Settings (Replication) (continued)
Out of Sync Notification
Settings
Configure Replication
Ports
IMPORTANT:
need to open (TCP) ports 9387 (Command protocol) and 9388 (Data protocol) to allow the
replication traffic to pass to and from the HP StoreOnce Backup systems.

Bandwidth Limiting tab

This tab allows users with an Admin login to apply a general bandwidth setting and to configure
bandwidth limiting windows.
Bandwidth limiting can be used to avoid saturating the WAN with low bandwidth replication, thus
freeing up bandwidth for other processes and applications that you may have running. A minimum
of 2Mbps per concurrent job is recommended. At least 512kbps per concurrent job is required
for reliable operation. These limits apply to all outbound replication jobs from this local appliance.
logging interval. While the library or share is out of sync emails are sent periodically
indicating how many slots or entries are still out of sync. This information is also logged to
the user Event Log. One email is sent for each log entry made for each library or share that
is out of sync.
Use these fields to specify the amount of time a mapping needs to be out of sync before a
sync issue is shown in the Issue tab, and an event is generated, resulting in an entry in the
user Event Log, and also an email and/or an SNMP trap if the appliance is configured to
send these. These notifications are in addition to a standard notification email sent whenever
a mapping first becomes unsynchronized and another when synchronization is achieved.
Replication ports should only be changed if replication is blocked by a router on the WAN.
They must be the same on both source and target appliances. If in doubt, do NOT change
them.
If replication needs to take place through a firewall, the network administrator will
Local Settings (Replication) tab 51