Source Appliances Tab; Source Appliance Permissions Tab - HP StoreOnce User Manual

NOTE:
address of the required service set. See also
set? (page
3. The default values for the Command and Data Protocol Port Numbers cannot be changed. If
replication needs to take place through a firewall, the network administrator will need to open
(TCP) ports 9387 (Command protocol) and 9388 (Data protocol).
4. Click Add Target Appliance.
To edit or remove a Target Appliance (administrators only)
Select the appliance and click Edit to edit the Appliance Name, IP address and protocol port
details of the target appliance.
Select the appliance and click Delete to remove an appliance from the list of Target Appliances
available to that source.
Run Traceroute
Click Run Traceroute to check that the local appliance can communicate with the target appliance
and identify the number of hops and latency in the routing.

Source Appliances tab

This tab allows you to view the details of all source appliances.
If the HP StoreOnce Backup system also has Replication-Target libraries, there may be multiple
Source Appliances.
NOTE: Source Appliances are appliances that have added the local appliance or service set as
a Target Appliance. Only Source Appliances that are currently connected to the Target Appliance
are listed.
The Source Appliances tab is not editable.
Table 12 Source appliance parameters
Source Appliance tab No fields are editable.
Appliance Name
Product Class
Appliance Address
Serial Number
Available
Capacity
Free Space
software version
Blackout windows

Source Appliance Permissions tab

Source Appliance Permissions are disabled by default. In this state, there is no control over mapping
between share and library devices on the Target and the Source Appliances.
This tab contains an Enabled checkbox that, when selected, allows administrators to lock down
the ability to create share and library mappings. When the Replication wizard is run and mappings
If the Target Appliance is on an HP B6200 Backup system, you must enter the VIF
41).
This is the name of the Source Appliance.
The product class of the appliance, such as HP B6000 or HP 4430.
This is the IP address of the Source Appliance.
This is the serial number of the Source Appliance.
This field indicates whether the Source Appliance is available.
This shows the capacity of the Source Appliance.
This shows the amount of free space on the Source Appliance.
This shows the software version of the Source Appliance.
Any blackout windows that have been specified will be reflected in this weekly calendar.
During these times, the selected Source Appliance is not available for replication.
How do I identify the IP address of a service
Partner Appliances (Replication) 47