Advertisement
4
Insert the Adaptec SCSI Card 29320ALP in the 64-bit (or 32-bit)
PCI or PCI-X expansion slot; press down firmly until the card
clicks into place, then replace the slot cover screw. When
installed properly, the card should appear level with the
expansion slot, as shown below.
Setting Up SCSI Devices
There are several things you may need to do to your SCSI devices
before you connect them to the Adaptec SCSI Card 29320ALP:
Check the SCSI IDs
Set the termination
Connect the power cables
Since setup can vary from device to device, always refer to the
device's documentation for specific instructions.
Following are some guidelines for setting SCSI IDs and termination
on your devices.
Check the SCSI IDs
The Adaptec SCSI Card 29320ALP and each device you connect to
it must have a unique SCSI ID number ranging from 0 to 15 on each
channel. No two devices on the same SCSI channel can have the
same SCSI ID.
4
Advertisement
