Table of Contents
Advertisement
C
ONNECTING
You can connect up to 15 SCSI devices to the Adaptec SCSI Card
29160. Before connecting devices, be sure to review Setting Up
SCSI Devices on page 7. For additional details on connecting
devices, refer to the Adaptec SCSI Card 29160 User's Reference.
N
OTE
connectors on the Adaptec SCSI Card 29160 at the same time.
Connecting Internal LVD SCSI Devices
Connect internal LVD SCSI devices to the internal LVD/SE
connector on the Adaptec SCSI Card 29160. To do this, use a
68-pin internal LVD cable like the one shown in Step 1 below.
Follow these steps to connect the devices:
N
OTE
separate from your SE (Ultra SCSI) devices. This allows LVD
SCSI devices to transfer data at their maximum speed. (See
Bus Segments on the Adaptec SCSI Card 29160 on page 4.)
Locate a 68-pin internal LVD SCSI cable, which may have either
S
1
TEP
twisted wires as shown below or flat, laminated wires.
Terminated End
SCSI D
EVICES
SCSI devices can be connected to all four SCSI
We recommend that you keep your LVD SCSI devices
Adaptec SCSI Card 29160
Nonterminated End
9
Advertisement
Table of Contents
