Adaptec 29320ALP Installation Manual page 4

3
Locate an unused 64-bit PCI/PCI-X expansion slot and remove
the expansion slot cover. If the computer does not have a 64-bit
slot, you can install the card in a 32-bit PCI slot. The Adaptec
SCSI Card 29320ALP supports both 5V and 3.3V 64-bit slots.
(The expansion slot must be compliant with PCI Rev. 2.1 or
PCI-X Rev. 1.0 and must support Bus Mastering.) Save the slot
cover screw for use in Step 4.
Slot cover screw
Expansion slot
cover
Computers may have vertical or horizontal expansion slots.
Refer to your computer manual to locate the PCI/PCI-X slots. If
your computer is a tower model, lay it on its side to allow for
easier installation of the Adaptec SCSI Card 29320ALP.
Warning: Be careful when inserting the Adaptec SCSI Card
29320ALP in a PCI slot. Some 32-bit slots will not
accommodate it, and the card may break if you force it into
the slot.
32-bit PCI slot
64-bit PCI slot
3