Accepting A New Configuration - Bosch VMS Operator's Manual

24 en | Getting started
–
–
–
–
–
–
5.5

Accepting a new configuration

When the system administrator activates a new configuration from within Configuration Client,
each Operator Client is either immediately restarted automatically or the user of a workstation
is informed about the new configuration and can accept it later. The system administrator
configures which of these 2 cases occurs.
If the system administrator activated a new configuration without forcing each Operator Client
workstation to accept the new configuration, a dialog box is displayed on all Operator Client
workstations. The users can refuse or accept the new configuration. The dialog box is closed
after a few seconds without user interaction. In this case the new configuration is refused. If a
device (for example a camera) is removed from the system in the new configuration, some
functions of this device are not available if you have refused the new configuration.
If you change the password for a user or delete a user while this user is logged on, this user
can still continue working with Operator Client after password change or deletion. If after
password change or deletion the connection to Management Server is interrupted (for
example after activating the configuration), the user cannot automatically reconnect to the
Management Server again without logoff/logon at Operator Client.
To accept a new configuration:
4
2013.07 | V1 | Operator Client
Handling alarms, Alarm List
Indication of recording
Indication of state changes
PTZ control locking
Analog monitor group
Scripts
Log off and then log on again.
The new configuration is used now.
Operator's Manual
Bosch Video Management System
Bosch Sicherheitssysteme GmbH