NEC Express5800 320La User Manual page 179

Table 5-3. POST Error Codes and Messages (continued)
Error Code and Message
0230 System RAM Failed at offset
0231 Shadow RAM Failed at offset
0232 Extend RAM Failed at
address line
0233 Memory type mixing detected DIMMs of the different types
0234 Single - bit ECC error
0235 Multiple - bit ECC error
0250 System Battery is Dead -
Replace and Run SETUP
0251 System CMOS Checksum
Bad - Default Configuration
Used
0252 Password checksum bad -
Password cleared
0260 System Timer Error
0270 Real Time Clock Error
0271 Check date and time setting
0280 Previous boot incomplete -
Default configuration used
02B0 Diskette drive A error
02B2 Incorrect Drive A type - run
SETUP
02D0
System cache error - Cache
disabled
0B1B PCI System Error on
Bus/Device/Function
0B1C PCI Parity Error on
Bus/Device/Function
Description
DIMM is faulty.
DIMM is faulty.
DIMM is faulty.
are installed.
DIMM is faulty.
DIMM is faulty.
No battery is available for
the system.
NvRAM is faulty.
NvRAM is faulty.
CPU module board is faulty.
Real-time clock error
Real-time clock is set
incorrectly.
Configuration error in Setup
menu.
Floppy drive A is faulty.
Configuration error in Setup
menu.
CPU is faulty.
CPU module board is
faulty.
PCI device is faulty.
PCI device is faulty.
Action
Replace DIMM.
Replace the CPU module
board.
Replace DIMM.
Replace the CPU module
board.
Replace DIMM.
Replace the CPU module
board.
Replace DIMM with
appropriate one.
Replace DIMM.
Replace the CPU module
board.
Replace DIMM.
Replace the CPU module
board.
Replace the CPU module
board.
Re-configure using the
Setup menu.
Replace the PCI module
board.
Re-set the password in the
Setup menu.
Replace the PCI module
board.
Replace the CPU module
board.
Replace the CPU module
board.
Set the correct date and
time in Setup menu.
Replace the PCI module
board.
Check configuration in
Setup menu.
Replace the floppy disk
drive A.
Specify the correct drive type
in Setup menu.
Replace the CPU.
Replace the CPU module
board.
Replace the PCI device
board.
Re-install the PCI device
board.
Re-configure the PCI
board.
Problem Solving 5-25