NEC Express5800 320La User Manual page 142

5. Pass the power cable through the rear panel cut out for the power cable
connector and secure the cable connector with the two screws provided in
the expansion kit. See Figure 4-69.
6. Connect the power cable to the power supply unit and secure its ground to
the server chassis. See Figure 4-70.
7.
Loosen the screws on the internal SCSI cable connectors, insert one of the internal
SCSI cable connectors into the bottom right-hand side connector slot on the rear
panel of the tape drive bay, and tighten the connector screws. Run and insert the
other end of the internal SCSI cable to the top right-hand side connector slot and
tighten its screws. The middle connector of the internal SCSI cable connector is
available for a 5.25-inch tape drive. This completes installation of the internal SCSI
cable for Group 1. See Figure 4-71.
8.
Repeat step 7 to install the internal SCSI cable for Group 2. The Group 2 connector
slots are located on the left-hand side of the rear panel. See Figure 4-71.
4-56 CRU Replacement and Server Upgrades
Figure 4-69. Installing the Power Cable
Figure 4-70. Connecting the Power Cable