Installing DIMMs
When properly installed, the DIMM module is oriented at an angle of 90
degrees relative to the CPU board.
1. Remove the appropriate CPU module from the server chassis. See Removing
a CPU Module earlier in this chapter.
2. Remove the top cover of the CPU module. See Installing a Processor earlier
in this chapter.
3. Slide and remove cooling fan #1 located in the front portion of the CPU
module. See Figure 4-24.
4. Tag and disconnect the cooling fan power cable from the CPU board. See
Figure 4-25.
Figure 4-25. Removing the Cooling Fan Power Cable
5. If you are replacing an existing DIMM, perform "Removing DIMMs" later
in this chapter and then go to step 7. Otherwise, continue with the next step.
Figure 4-24. Removing Cooling Fan #1
CRU Replacement and Server Upgrades 4-23