NEC Express5800 320La User Manual page 134

Figure 4-58. Removing the Locking Handle Screw
5. Pull the locking handle down to its fully opened position. This disconnects
the power supply from its connector inside the bay. See Figure 4-59.
6. Use the locking handle to pull the power supply out of the bay just enough
so that you can support the power supply with both hands. Then carefully
remove the power supply from the bay. See Figure 4-59.
7. To reinstall the power supply in the cabinet make sure that its locking handle
is in its unlocked position (down 45 degrees). Then insert the power supply
into the power supply bay and slowly slide it inward until it is almost flush
with the rear of the bay. Figure 4-60.
4-48 CRU Replacement and Server Upgrades
A Locking handle
B Screw
Figure 4-59. Removing the Power Supply
A
B