NEC Express5800 320La User Manual page 127

6. Position the drive so its SCA connector is near the top surface of the drive.
Place the drive on the antistatic surface again. Slide the drive into the carrier
with its SCA connector facing toward the rear of the carrier (open end).
7. While holding the drive in the carrier with your left hand, align the drive's
screw holes with the carrier's screw holes and insert the four screws of
appropriate size and length (see Figure 4-51).
D
C
B
Figure 4-51. Installing Hard Disk Drive in a Carrier
8. Unlock the lock lever located at the bottom of the carrier handle, see
Figure 4-52.
Figure 4-52. Unlocking the Carrier Lock Lever
9. Hold the handle of the hard disk drive carrier firmly and insert the carrier
into the slot until the hook at the bottom of the lock lever engages the frame,
see Figure 4-53.
Installing 3 1/2inch hard disk
drive in carrier for hot-swap
bays
A Carrier
B Four screws
C Hard disk drive
D SCA connector
A
CRU Replacement and Server Upgrades 4-41