Advertisement
Step 2
Sliding the server out from the rack
It is necessary to slide the server out from the rack when doing maintenance of the internal
components. This step describes the procedures for sliding the server out from the rack.
Note sufficiently that your fingers may not be caught between a rail and
other mechanical parts or cut by a rail at installation or removal of the
server from the rack.
(1) Loosen four captive thumbscrews on the front of the server.
(2) Grasp the two handles on the front of the server slowly pull it out until it stops (locks)
by the release levers.
(3) Do the maintenance of internal components according to the manual of the server.
(4) Carefully press down the release levers on the inner rails to release the locks and slide
the server all the way into the rack.
(5) Grasp the two handles on the front of the server slowly push it in until it stops.
(6) Tighten four captive thumbscrews on the front of the server.
Front Cover
Captive thumbscrews
Release Lever
‚P‚T
856-122660-101-A Rev.1.2
Advertisement
