Installation and Assembly - Universal Model: NP01UCM Ceiling Mount Maximum Load Capacity: 50 lb (22.7 kg) Read instruction sheet before you start installation and assembly. WARNING • Make sure that the supporting surface will safely support the combined load of the equipment and all attached hardware and components.
Before you start check the parts list to insure all of the parts shown are included. Parts List Description Qty. Part Number A ball and socket mount 055-0016 B 4 mm security allen wrench 560-9646 C M5 x .8 x 10 mm socket pin type F screw 520-2031 D #10-32 x 3/8"...
Installation To Wood Joist Finished Ceilings, Exposed Wood Joists, or Wood Beam Ceilings WARNING • Tighten wood screws (F) so that ceiling plate (G) is firmly attached, but do not overtighten. Overtightening can damage the screws, greatly reducing their holding power. •...
Installation to Concrete Ceilings WARNING • When installing ceiling mounts on concrete, verify that you have a minimum of 1 5/8" of actual concrete surface in the 1/4" diameter hole to be used for the concrete anchors. Do not drill into mortar joints! Concrete must meet ASTM C-90 specifications.
Flush Mount Application Screw ball and socket mount (A) into ceiling plate (G). Align the notch with one of the four holes of the ceiling plate (G) and secure ball and socket mount (A) with a M5 x 10 mm socket pin screw (C) using security allen wrench (B) as shown in detail 1.
Installation to Extension Column Screw extension column to ceiling plate (G). Align the notch with one of the four holes in the ceiling plate (G) and secure extension column with a M5 x 10 mm socket pin screw (C) using security allen wrench (B).
Attaching Universal Adapter Plate to Projector NOTE: The projector you are installing may differ in appearance from the sample illustrated below. Place projector upside down. Locate adapter plate (L) with notch facing forward as close to projector center of gravity as possible without covering any mounting holes. Loosen channels, and if there are only three mounting holes remove fourth channel.
NOTE: The projector adapter plate and projector you are installing may differ in appearance from the sample illustrated below. To adjust roll, pitch, and yaw loosen the set screw Attach projector, with adapter plate already on it, to the (shown below) using security allen wrench (B) or ball and socket mount (A) by inserting the ball and standard 4 mm allen wrench.