Sanitizing Procedure - Following Cleaning Procedure - Hoshizaki KMS-1122MLH Instruction Manual

8) In bad or severe water conditions, clean the float switch as described below. Otherwise,
continue to step 9.
a. Remove the float switch assembly.
b. Remove the retainer rod from the bottom of the float switch housing, then remove
the float. Be careful not to bend the retainer rod excessively when removing it.
c. Wipe down the float switch assembly's housing, shaft, float, and retainer rod with
cleaning solution. Rinse the parts thoroughly with clean water.
d. Reassemble the float switch assembly and replace it in its correct position.
9) Pour the cleaning solution into the water tank.
10) Move the service switch to the "WASH" position.
11) Replace the side insulation, left side, top, apron, and front panels in their correct
positions.
12) Turn on the power supply to start the cleaning process.
13) Turn off the power supply after 30 minutes. Remove the front panel.
14) Move the service switch to the "DRAIN" position.
15) Replace the front panel in its correct position, then turn on the power supply for
2 minutes to drain the water tank.
16) Turn off the power supply, then remove the front panel.
17) Move the control switch to the "ICE" position.
18) Replace the front panel in its correct position, then turn on the power supply for
3 minutes to fill the water tank.
19) Turn off the power supply, then remove the front panel.
20) Move the control switch to the "SERVICE" position, then move the service switch to the
"WASH" position.
21) Replace the front panel in its correct position, then turn on the power supply for
5 minutes to rinse off the cleaning solution.
22) Turn off the power supply, then remove the front panel.
23) Move the service switch to the "DRAIN" position.
24) Replace the front panel in its correct position, then turn on the power supply for
2 minutes to drain the water tank.
25) Turn off the power supply, then remove the front panel.
26) Repeat steps 17 through 25 three more times to rinse thoroughly.
Note: If you do not sanitize the icemaker, go to step 13 in "III.B.2. Sanitizing Procedure."

2. Sanitizing Procedure - Following Cleaning Procedure

1) Dilute 2.5 fl. oz. (74 ml or 5 tbs) of a 5.25% sodium hypochlorite solution (chlorine
bleach) with 5 gal. (19 l) of warm water.
2) Remove the front, apron, top, left side, and side insulation panels if they are in their
normal positions.
3) Pour the sanitizing solution into the water tank.
31