Setup; Dispenser Unit/Ice Storage Bin And Icemaker Setup - Hoshizaki KMS-1122MLH Instruction Manual

D. Setup

1. Dispenser Unit/Ice Storage Bin and Icemaker Setup

The installer must ensure the dispenser unit/ice storage bin is compatible with
the icemaker, and the dispenser unit/ice storage bin and icemaker are properly
attached and secured.
• Do not connect the icemaker to an external power source. Icemaker power supply
and ground connection are supplied from the remote condensing unit via the wire
bundle provided with the remote condensing unit. For details, see "II.F. Electrical
Connection."
• Before operating the icemaker, the bin control must be installed correctly. Failure
to properly install the bin control could result in ice backup and unit damage.
1) If mounting the icemaker on top of a dispenser unit, follow the dispenser unit's setup
procedure. If mounting the icemaker on top of an ice storage bin, unpack the ice storage
bin and attach the 4 adjustable legs provided (bin accessory) to the bottom of the ice
storage bin.
2) Position the dispenser unit/ice storage bin in its permanent location.
3) If required, install an adapter kit or top kit. Contact your local Hoshizaki distributor for
recommendations.
4) Level the dispenser unit/ice storage bin in both the left-to-right and front-to-rear
directions. If using an ice storage bin, adjust the ice storage bin legs to level.
5) Place the icemaker on top of the dispenser unit/ice storage bin.
6a) Dispenser Unit: Follow the dispenser unit's instructions for securing the icemaker to
the dispenser unit. If no instructions are available, secure the icemaker to the dispenser
unit using the mounting brackets provided. If the installation requires the dispenser unit
to extend 2 inches beyond the back of the icemaker, use the offset mounting brackets.
See Fig. 5a. If the icemaker is flush with the back of the dispenser, use the standard
mounting brackets and rotate them so that they fit flush to the icemaker and dispenser
unit. Secure the mounting brackets to the icemaker with the machine bolts provided.
Secure the mounting brackets to the dispenser unit with the self-tapping bolts provided.
NOTICE! Use care to avoid damage to dispenser unit components when attaching
the mounting brackets.
6b) Ice Storage Bin: Secure the icemaker to the ice storage bin using the standard
mounting brackets and the machine bolts provided. See Fig. 5b.
WARNING
NOTICE
13