Sanitizing Procedure - Following Cleaning Procedure - Hoshizaki IM-500SAB Instruction Manual

19) Replace the front panel.
20) Turn on the power supply for 3 minutes. The water tank drains.
21) Turn off the power supply.
22) Repeat steps 20 and 21 three more times to rinse thoroughly.
Note: If not sanitizing the icemaker, go to step 19 in "III. A. 2. Sanitizing Procedure. "

2. Sanitizing Procedure - Following Cleaning Procedure

1) Dilute a 5.25% sodium hypochlorite solution (chlorine bleach) with water (add
approximately 0.4 fl. oz. (12 ml) to 0.8 gal. (3.0 l) of water).
2) Close the icemaker water supply line shut-off valve.
3) Turn on the power supply for 3 minutes. The water tank drains.
4) Turn off the power supply.
5) Remove the front panel and top panel.
6) Move the control switch to the "WASH" position.
7) Slowly pour the sanitizing solution over the top of the evaporator and into the water tank.
Do not splash or spill the solution onto other parts.
8) Replace the front panel and top panel in their correct positions.
9) Turn on the power supply to start the sanitizing process.
10) Turn off the power supply after 15 minutes.
11) Open the icemaker water supply line
shut-off valve.
12) Remove the front panel.
13) Move the control switch to the "ICE"
position.
14) Replace the front panel.
15) Turn on the power supply for 3 minutes.
The water tank drains.
16) Turn off the power supply.
17) Repeat steps 15 and 16 three more times
to rinse thoroughly.
18) Repeat steps 1 through 17 one more time.
19) Remove the front panel.
20) Remove the screw, then move the water
tank drain pipe to the normal position.
See Fig. 5. Use the screw to secure the
water tank drain pipe in the normal position.
21) Replace the front panel.
22) Clean the storage bin liner using a neutral
cleaner. Rinse thoroughly after cleaning.
23) Turn on the power supply to start the automatic icemaking process.
[Normal Position]
[Drain Position]
19
Tank Drain
Pipe
Fig. 5
Screw