Healthrider Crosstrainer 1050 T Elliptical User Manual page 8

7. Attach the Left Handlebar Cover (102) to the Console
(5) with three M4 x 16mm Screws (66). Attach the
Right Handlebar Cover (103) in the same way.
See step 4. Tighten the eight M6 x 16mm Tapered
Screws (71).
8. Identify the Left Handlebar (9), which is marked with a
sticker. Insert the Left Handlebar into one of the
Handlebar Legs (79); make sure that the Handlebar
Leg is turned so the hexagonal holes are on the
indicated side. Attach the Left Handlebar with two M8
x 45mm Button Bolts (50) and two M8 Nylon Locknuts
(46). Make sure that the Nylon Locknuts are inside
of the hexagonal holes. Do not tighten the Button
Bolts yet.
Apply a generous amount of the included grease to the
Pivot Axle (92) and to the two M8.5 Washers (53). Next,
insert the Pivot Axle into the Upright (2) and centre it.
Reapply grease to both ends of the Pivot Axle.
Slide a Handlebar Spacer (25) onto the short tube on
the Left Handlebar (9), and rotate the Handlebar Spacer
so the small arrow is pointing toward the floor. Next,
slide the Left Handlebar onto the left end of the Pivot
Axle (92). Finger tighten an M8 x 25mm Patch Screw
(22) with an M8.5 Washer (53) and a Wave Washer (94)
into the end of the Pivot Axle. Then, press the small tabs
on a Handlebar Cap (23) into the Handlebar Spacer.
Assemble the Right Handlebar (not shown) and the other
Handlebar Leg (not shown) in the same way.
Tighten both M8 x 25mm Patch Screws (22) at the same
time. Make sure that the Wave Washers (94) are on the
ends of the Pivot Axle (92).
7
66
102
8
Grease
9
53
22
94
23
50
79
8
5
103
2
92
2
Tube
25
Arrow
46
Hexagonal
Holes