Assembly - Healthrider 875p Treadmill User Manual

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials; do not
dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking
belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to
the top of the walking belt or the shipping carton. This does not affect treadmill performance. If there is lubricant
on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.To pro-
tect the floor or carpet from damage, place a mat under the treadmill.
Assembly requires the included hex key
spanner , and rubber mallet
As you assemble the treadmill, use the drawings below to identify hardware. Note: The hardware is packaged
in separate parts bags. Each parts bag is marked to show which assembly steps require the hardware in
that parts bag. Do not open the parts bags until instructed to do so. If a part is not found in the parts
bags, check to see if it has been preassembled. Some part bags may include extra hardware.
Star Washer (111)–4
1/2" Silver
Screw (114)–2
3/4" Tek Screw (35)–8
1. Do not plug in the power cord until all assembly
steps are completed.
With the help of a second person, carefully tip the
treadmill onto its left side as shown. Partially fold the
Frame (51) so the treadmill will be more stable. Do not
fully fold the treadmill until it is completely assem-
bled.
Open parts bag 1–2. Attach the six Base Pads (44) to
the bottom of the Base (116) with six 1" Tek Screws (13).
Note: Only three Tek Screws are shown.
and your own phillips screwdriver
Nut (3)–2
1/2" Tek Screw
1/2" Screw
(113)–2
(33)–4
3/4" Screw (37)–20
.
Plastic Fastener (9)–4
Wheel Bolt (56)–2
Upright Bolt (112)–4
1
13
44
116
6
, adjustable
1" Tek Screw (13)–6
51
13
44