Healthrider 875p Treadmill User Manual page 8

5. Tighten a 1/2" Tek Screw (113) into the right side of the
Crossbar (46) and the Right Upright (55).
Attach the Console Base (38) to the Uprights (55, 64) with
four 1/2" Screws (33). Make sure that the Wire Harness
(49) is not pinched. Insert any excess Wire Harness into
the Right Upright. Securely tighten the plastic tie around the
Wire Harness and cut off the end of the tie.
Locate the two plastic ties on the Crossbar (46) and re-
move them.
See step 4. Tighten the 1/2" Tek Screw (113).
6. Open parts bag 6–9. Turn a Handrail Extension (34) so
the two larger holes are on the bottom. Insert the
Handrail Extension as far as possible into the post on the
left Upright (64). If necessary, tap the Handrail Extension
with a rubber mallet to fully insert it. Next, attach the
Handrail Extension by tightening three 3/4" Tek Screws
(35) into the indicated holes.
Identify the Left Foam Grip (31) (see the inset drawing).
Remove the paper from the two indicated blocks of
Foam Tape (82). Apply a small amount of water to the
blocks of Foam Tape. Slide the Left Foam Grip as far as
possible onto the post on the left Upright (64). (Note: It
may be helpful to lubricate the Handrail Extension
[34] with soapy water.) Press two Plastic Fasteners (9)
into the Foam Grip and the Handrail Extension. If neces-
sary, use a blunt object to press in the Fasteners.
Attach the other Handrail Extension (not shown) and the
Right Foam Grip (43) as described above. Note: Make
sure that the 3/4" Tek Screws (35) are attached on the
outside of the post as shown.
7. Attach a Wheel (58) to the right side of the Base (116)
with a Wheel Bolt (56) and a Nut (3) as shown.
Attach a Wheel to the left side of the Base (not shown) in
the same way.
5
49
Tie
113
33
6
9
7
3
8
38
46
Ties
64
33
55
82
35
Post
31
34
64
Holes
31
43
116
58
56