Healthrider 875p Treadmill User Manual page 9

8. Carefully lower the Uprights (55, 64) as shown.
Open parts bag 10. Press the Console Back (40) onto
the back of the Console Base (38). Make sure that
Console Back and the Console Base are mated cor-
rectly and that no wires are pinched. Tighten two 1/2"
Silver Screws (114) into the indicated holes. Tighten 3/4"
Screws (37) into the other holes in the Console Back.
Make sure that the deck is centred between the Left
Upright (64) and the Right Upright (55). Firmly tighten—but
do not overtighten—the four Upright Bolts (112) (only two
are shown) in the Base (116).
Insert the Left and Right Cup Holders (39, 50) into the
large holes in the Console Base (38). If there is a small
hole under each Cup Holder, the two Small Clamps (117)
should be attached. See the inset drawing. Loop a Small
Clamp through the hole in the bottom of a Cup Holder and
attach it with a 3/4" Screw (37). Attach a Small Clamp to
the other Cup Holder in the same way.
Raise the Uprights (55, 64) back to the vertical position.
9. Make sure that all parts are properly tightened before you use the treadmill. Keep the included hex key
in a secure place; the hex key is used to adjust the walking belt (see page 26).
8
114
39
37
117
9
37
40
114
55
64
Deck
112
116
50
38