Healthrider 875p Treadmill User Manual page 7

2. Identify the Right and Left Uprights (55, 64); the Left
Upright has two small holes near the square post.
Hold the Right Upright (55) near the Base (116), and ori-
ent the Right Upright as shown. Make sure that the
Right Upright bends in the direction shown. Straighten
the Wire Harness (49), and feed it into the lower end of
the Right Upright and out of the upper end. Make sure
that the Wire harness is not pinched. Hand tighten two
Upright Bolts (112) with Star Washers (111) into the bot-
tom of the Base (116) and the lower end of the Right
Upright.
Attach the Left Upright (64) as described above. Note:
There is not a wire harness on the left side.
3. With the help of a second person, carefully tip the tread-
mill back down so that the Uprights (55, 64 [not shown])
are vertical. Make sure that the end of the Wire
Harness (49) does not fall into the Right Upright.
Set the Console Base (38) on the Right Upright (55) as
shown. Check the pins in the connector on the Wire
Harness and make sure that they are straight. Connect
the Wire Harness to the indicated connector on the back
of the Console Base. Make sure to insert the connec-
tors properly (see the inset drawing). The connectors
should slide together easily and snap into place. If the
connectors do not slide together easily and snap into
place, turn one connector and try again.
Insert the included plastic tie through the small hole in the
Right Upright (55) and around the Wire Harness (49) as
shown. Connect the two indicated ground wires.
4. Open parts bag 4–5. Loosely thread a 1/2" Tek Screw
(113) into the left side of the Crossbar (46) and the Left
Upright (64). Note: The Tek Screw may be preassembled
in the Left Upright.
Attach the Latch Assembly (32) to the Left Upright (64)
with two 3/4" Tek Screws (35).
2
112
111
49
112
111
3
38
Tie
55
4
(Leave loose) 46
32
35
64
7
116
Holes
Bend
49
Ground Wires
49
113
55
64