Auto Setup As - Fluke 225C Programming Reference Manual

=============================================================
-------------------------------------------------------------
Purpose:
Invokes an automatic setup for the active mode. The result
of this command is the same as pressing the AUTO key
on the ScopeMeter.
Note: You can select the items that are affected by the
AUTO SET procedure via the USER OPTIONS key on
the ScopeMeter.
Command Syntax:
AS<cr>
Response Syntax:
<acknowledge><cr>
Example:
The following example program sends an AUTO SETUP command to
the ScopeMeter. Connect a repetitive signal on
INPUT A to see the effect of AUTO SETUP.
Page 3.5
AUTO SETUP AS