Default Setup Ds - Fluke 225C Programming Reference Manual

=============================================================
-------------------------------------------------------------
Purpose:
Resets the ScopeMeter to the factory settings at
delivery, except for the RS232 communication settings such
as baud rate, to keep the communication alive.
A Master Reset (refer to the Users Manual) performs the
same, but also resets the RS232 communication settings to
the default values.
Command Syntax:
DS<cr>
Response Syntax:
<acknowledge><cr>
Note: Wait for at least 2 seconds after the
<acknowledge> reply has been received, to let
the ScopeMeter settle itself before you send the
next command.
Example:
Page 3.13
DEFAULT SETUP DS