Fluke 225C Programming Reference Manual page 60

============================================================
------------------------------------------------------------
Purpose:
Queries the present acquisition setup data from the
ScopeMeter.
Command Syntax:
QS [<setup_no>]<cr>
where,
<saved_setup_no> = 0
Response Syntax:
<acknowledge><cr>[#0{<node>}<cr>]
where,
<node> =
<node_header> = <binary_character>
<node_identifier> = <binary_character>
<node_length> = <unsigned_integer>
<node_data> =
<check_sum> =
Note: Also see the Program Setup (PS) command.
See an example for this command under PROGRAM SETUP (PS).
Page 3.42
QUERY SETUP
<node_header><node_identifier><node_length>
[<node_data>]<check_sum>
Possible values:
20 hex
A0 hex
Unique number for each specific node.
Specifies the number of <binary_character>
fields that follow in the <node_data>
field.
{<binary_character>}
The contents of <node_data> depends on the
<node_identifier> and the selected setup.
<binary_character>
Contains the sum of all the binary bytes
in the <node_data> field.
: Actual setup
All nodes except the last (end
node)
End node
QS