Device Configuration Jumper - Toshiba SD-M1212 - DVD-ROM Drive - IDE Specifications

9. Device Configuration Jumper

9.1. Device configuration jumper (MODE SELECT)
The device configuration jumper is a 6-pin, right angle and header (Molex P/N70203 or equivalent)
with three marked positions.
C S M
S L A
(a)
(a) Use CS (CSEL)
The device shall use the host interface signal CSEL to configure the device.
(b) MA (Master): Default Position
The device shall use for the Master.
Default Mode is 'MA'.
(c) SL (Slave)
The device shall use for the Slave.
C S M C
S L A S
(b)
S M C
L A S
Cable CSEL
(c)
Figure 14
23/28
Vcc
S M
L A
Drive CSEL
GND
SD-M1212 Rev.1.0