Download  Print this page

Cd Audio; Analog Out; Digital Out; Connector - Toshiba SD-M1212 - DVD-ROM Drive - IDE Specifications

Dvd-rom drive
Hide thumbs

Advertisement

8.CD Audio (Test condition: Ordinary temperature)
8.1. Analog Out --- in case of the attenuator is set at 0 dB by the command ---
(1) Output Level
(2) Type
(3) Load Impedance
(4) Frequency Response
(5) Distortion
(6) Signal to Noise Ratio

8.2. Digital Out

(1) Output Level
(2) Type
(3) Load Impedance

8.3.Connector

4P connector and 2P connector (Use matching housing, Part No. 70066, made by Molex
Corporation or equivalent.)
Digital Audio
Digital out

8.4. Audio Modes

(1) 16 Modes including 'Stereo', 'Lch Mono', 'Rch Mono' and 'Mute' are selectable by command.
Default mode is 'Stereo'. Audio out is automatically muted in the digital data area and seek state.
(2) 16 Steps of attenuation level for the Audio Output is selectable by command.
Default level is 0 dB.
8.5. Headphones Output (Option).....in case of the attenuator set at 0 dB by the command.....
(1) Output Level
(2) Level Adjust Controller
(1) Load Impedances
8.5.1. Connector
3.5 mm dia. Stereo Headphones Jack.
#2
#1
GND
0.60 V (rms Typ)
Continuous Type (Thumb Wheel Knob)
100 OHM (Nominal)
0.85 V (rms Typ)
Unbalanced
47 kOHM min
20 Hz to 20 kHz +/-3 dB
0.04 % Max. (at 1 kHz w/20 kHz LPF)
80 dB Typ (IEC 179 A-weighted)
0.61V p-p
Unbalanced
75 OHM
#4
R
Figure 13
22/28
Analog Audio
#3
#2
#1
GND
GND
L
SD-M1212 Rev.1.0

Advertisement

loading

  Related Manuals for Toshiba SD-M1212 - DVD-ROM Drive - IDE