Warranty; Specifications - Repeater Port Module (Rpm); Specifications - Bridge Port Module (Bpm) - GarrettCom Magnum 1016 Installation And User Manual

Magnum 1000 Workgroup Hubs
Power Supply (Internal)
AC Power Connector: IEC-type, male recessed, rear of chassis
Input Voltage: 90 to 260 VAC (auto-ranging)
Input Frequency: 47 to 63 Hz (auto-ranging)
Power Consumption: 10 watts typical, 20 watts max. P.S. rating
(For 48VDC power input option, see Appendix B).
Agency Approvals
UL Listed (UL 1950), cUL, CE
Emissions meet FCC Part 15 Class A

Warranty

Three years, return to factory
1.2 Specifications - Repeater Port Modules (RPMs)
RPM Type :
Front Access
Connector Type
Partition (PART)LED
Receive (RX) LED
LINK LED
Switch on Face Plate
yes***
"Fiber-mm" is multi-mode cable, normally used for 10BASE-FL installations, up to
2.0Km.
"Fiber-sgl.m" is single-mode cable, used for distant installations, up to 10.0Km.
* The RJ-45 connector is shielded; it accepts RJ-45 eight-pin plugs for unshielded
and shielded twisted pair wiring.
** Internal termination switch for BNC, no "T" connector is required.
*** MDI-X (Media Dependent Interface - Crossover) switch for RJ-45 up-link,
1.3 Specifications - Bridge Port Modules (BPMs)
BPM Type :
Connector Type
Switch on FP
FWD-I LED
FWD-X LED
LINK LED
* The RJ-45 connector is shielded; it accepts RJ-45 eight-pin plugs for unshielded
and shielded twisted pair wiring.
** Internal termination switch for BNC, no "T" connector is required.
*** MDI-X (Media Dependent Interface - Crossover) switch for RJ-45 up-link,
.
www GarrettCom com
BNC
yes
BNC-f DB-15 f DB-15 m
yes
yes
n.a.
yes**
no crossover cable is required.
BNC
BNC(f) DB-15(f)
yes**
yes
yes
n.a.
no crossover cable is required.
.
Installation and User Guide (04/02)
AUI DTE Fiber-mm Fiber-sgl.m
yes yes
yes yes
yes yes
n.a. n.a.
n.a. n.a.
AUI Fiber
ST
n.a. n.a.
yes yes
yes yes
n.a. yes
2
Made in USA
yes yes
Fiber-ST Fiber-ST
yes yes
yes yes
yes yes
n.a. n.a.
TP*
RJ-45
yes***
yes
yes
yes
TP*
yes
RJ-45
yes
yes
yes