Cisco ASR 903 Release Notes page 262

Caveats in Cisco IOS XE 3.10S Releases
Conditions: This issue is observed when you have ATM and IMA configured and perform an SSO.
IOMd crashes and the IM goes out of service.
Workaround: There is no workaround.
CSCue54997
•
Symptom: The system accepts two input clock sources from the same OC3 IM although the system
supports only one input clock source per OC3 IM. This results in clock failures.
Conditions: This issue is observed when two input clock sources are accepted from the same OC3
IM although the framer on the IM can support only one clock source.
Workaround: Do not configure the second input clock source from the same OC3 IM.
Alternatively, remove both OC3 clock sources and configure the desired OC3 controller.
CSCue57671
•
Symptom: Router crashes while running the REP configuration.
Conditions: This issue is observed while removing the REP configuration from the interface.
Workaround: There is no workaround.
• CSCue66019
Symptom: The router displays MLPPP interface errors.
Conditions: This issue is observed when there is more than 90% line rate traffic with mix MTU
patterns.
Workaround: There is no workaround.
CSCue67835
•
Symptom: OSPF flaps when you set the dead interval timer as 6 seconds and hello interval as 2
seconds.
Conditions: This issue is observed when you perform an SSO.
Workaround: Use the default OSPF hello timers.
CSCue72481
•
Symptom: The same interface accepts an IP address and a MEP.
Conditions: This issue is observed when you configure an IP address and a MEP to the same
interface.
Workaround: There is no workaround.
CSCue83621
•
Symptom: Policy map stops working after you dynamically remove class default class.
Conditions: This issue is observed when the policy map is attached to the target and the class default
of the top level is deleted dynamically, the policy stops working.
Workaround: Detach and reattach the policy map on the target.
CSCue89503
•
Symptom: The power supply status reports critical after you remove and insert the power supply.
Conditions: This issue is observed after performing multiple OIRs.
Workaround: There is no workaround.
CSCuf01120
•
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
20
Chapter
OL-26630-08