Resolved Caveats-Cisco Ios Xe Release 3.7(3)S - Cisco ASR 903 Release Notes

Chapter
•
•
•
Resolved Caveats—Cisco IOS XE Release 3.7(3)S
This section documents the issues that have been resolved in Cisco IOS XE Release 3.7(3)S.
•
•
OL-26630-08
Issue an stateful switchover (SSO)
–
Workaround: There is no workaround.
CSCuf86184
Symptom: The show interface BDI command does not display the incrementing of counters when
traffic is flowing.
Conditions: This issue occurs after executing the show interface BDI command.
Workaround: There is no workaround.
CSCug30714
Symptom: OSPF flaps occur on interface module stop.
Conditions: This issue occurs when the interface module stops.
Workaround: There is no workaround.
CSCud96866
Symptom: The router displays the following symptoms:
Object download failures
–
OSPF traffic flaps
–
– High CPU utilization
– Bundling and unbundling of port-channel member links
– Slow console updates
Remote MEP learning failures
–
Conditions: Occurs when you configure CFM offloaded MEPs for xconnect on a port-channel
interface at a high scale and issue a shutdown/no shutdown on the port-channel interface.
Workaround: There is no workaround.
CSCty30951
Symptom: The router displays the following console error message:
%QOSMGR-3-OUT_OF_TCAM_RESOURCES: SIP0: nile_mgr: Out of tcam resources to execute
command
Conditions: Occurs when you remove a QoS configuration by setting the interface to the default
configuration.
Workaround: There is no workaround.
CSCty34054
Symptom: The router displays CPU utilization traceback messages and drops all multicast traffic
for 2050 seconds.
Conditions: Occurs under the following conditions:
– Multicast is enabled with more than 500 multicast groups.
The router is using RSP1B in SSM mode.
–
BDI is configured on the access side of the router.
–
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
Caveats in Cisco IOS XE 3.7S Releases
19