Cisco ASR 903 Release Notes page 150

Caveats in Cisco IOS XE 3.8S Releases
CSCud04161
•
Symptom: The router incorrectly displays a CFM Delay Measurement Message (DMM) value of 0.
Conditions: This issue occurs under any of the following conditions:
–You dynamically add a member link to a port-channel.
–You issue a shutdown command followed by no shutdown command on a member link of a
port-channel.
Workaround: Wait for PTP to synchronize before configuring DMM scheduling.
CSCud09142
•
Symptom: Fp active errors are displayed after removing the tunnel-tp interface with
high-availability configured.
Conditions: This issue occurs after removing the tunnel-tp interface.
Workaround: There is no workaround.
CSCud28982
•
Symptom: The router does not process egress QoS marking on an Ethernet service instance.
Conditions: Occurs when you configure QoS on an Ethernet service instance that is a member of a
bridge-domain and uses dot1q encapsulation.
Workaround: There is no workaround.
CSCud30554
•
Symptom: Object download failure messages are displayed on console during object cleanup. This
would cause a possible leak in the hardware resource if the objects are not cleaned up later.
Conditions: This issue occurs during object cleanup and during the VC deletion.
Workaround: There is no workaround.
CSCud37927
•
Symptom: The router does not learn remote Connectivity Fault Management (CFM) Maintenance
Endpoint (MEPs) and FPGA gets stuck.
Conditions: This issue occurs under the following conditions:
–
–
–
Workaround: There is no workaround.
CSCud61551
•
Symptom: Serial Number of the RSP in slot 1 does not display in the show inventory command
output.
Conditions: This issue occurs under unknown conditions.
Workaround: Reload the router.
CSCud64436
•
Symptom: The router does not send the full line rate on POS interfaces.
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
8
UP MEP and more than one port on the core side connected to the other router.
If REP or STP is already configured on core interface, and then UP MEP is configured.
REP or STP is running and one of the port is ALT or BLK state and a shutdown followed by a
no shutdown is performed on the interface. Or an OIR of the IM is performed causing REP/STP
state changes and the FPGA gets stuck.
Chapter
OL-26630-08