Resolved Caveats-Cisco Ios Xe Release 3.8(2)S - Cisco ASR 903 Release Notes

Caveats in Cisco IOS XE 3.8S Releases
•
Resolved Caveats—Cisco IOS XE Release 3.8(2)S
This section documents the issues that have been resolved in Cisco IOS XE Release 3.8(2)S.
•
•
•
•
•
•
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
12
Workaround: Manually resolve the ARP by pinging the BDI interface.
CSCug52920
Symptom: EFP stats does not work after applying the QoS policy on the EFP.
Conditions: This issue occurs when service policy is applied on the EFP.
Workaround: There is no workaround.
CSCub80685
Symptom: Ping failure observed and BFD or OSPF flaps on BDI shut.
Conditions: This issue occurs after shutting down the BDI interface which is receiving IPv4 or IPv6
traffic. Similar conditions occur on no EFP or BDI configured or no IP address is configured.
Workaround: Stop routing traffic into shut BDI port.
CSCub89304
Symptom: Remote meps not learnt for CFM UP MEPS on EVC BD.
Condition: This issue occurs when IP MEPS are configured on EVC BD and Core side has
port-channel with Trunk EFP configured.
Workaround: There is no workaround.
CSCub89531
Symptom: Multicast statistics in the MFIB output display NA/NA. This causes multicast traffic to
drop every 3 minutes once the 3 minute timer expires.
Conditions: This issue occurs after an stateful switchover (SSO) is performed.
Workaround: Issue another SSO or reload the router.
CSCuc41871
Symptoms: ATM interfaces stay down during normal operations.
Conditions: This issue occurs under the following conditions:
1. Post router reload is performed
2. Peer interface cable is pulled out & put back in.
Workaround: Perform an interface reset by issuing the shutdown command followed by a no
shutdown command.
CSCuc76353
Symptom: Boot flash is inaccessible in ROMMON and IOS prompt.
"dir bootflash:" CLI does't display boot flash contents.
Condition: This issue is observed randomly on bootup. This issue is mostly observed when access
to the boot flash gets interrupted because of system reload or system crash. In these cases, boot flash
goes to unknown state and is not accessible either from the ROMMON or IOS.
Workaround: Perform an OIR or power cycle of the RSP to recover the boot flash errors.
CSCud13242
Chapter
OL-26630-08