Cisco ASR 903 Release Notes page 100

Caveats in Cisco IOS XE 3.7S Releases
CSCuf07508
•
Symptom: The Gigabit Ethernet port on interface module does not come up after a reload.
Conditions: This issue occurs when the Cisco ASR 903 router is reloaded multiple times.
Workaround: Perform an OIR of the interface module.
CSCuf79397
•
Symptom: The F1 interface is stuck in init state after OIR of the standby RSP or standby reload.
Conditions: This issue occurs after the standby RSP is reloaded or OIR is performed.
Workaround: There is no workaround.
CSCub94462
•
Symptom: The router displays object download error messages on the console similar to the
following example:
%FMFP-3-OBJ_DWNLD_TO_CPP_FAILED"
Conditions: Occurs when you take the following actions:
–
–
–
–
Workaround: Do not issue clear mac-address-table command when the mac security sticky is
configured.
• CSCue51682
Symptom: The REP protocol flaps, as indicated by the following error messages:
*Feb
non-operational due to neighbor not responding
*Feb
operational
Conditions: Occurs under the following conditions:
–
–
–
Workaround: Remove fast LSL from the REP configuration.
CSCuf86247
•
Symptom: SNMP MIB variables related to BDI counters do not function properly.
Conditions: Occurs when you use SNMP MIB variables related to BDI interface counters.
Workaround: There is no workaround.
CSCug05491
•
Symptom: The router drops traffic on VPLS circuits.
Conditions: Occurs when you take the following actions:
–
–
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
18
Apply the mac address sticky command
Configure 25 incremental MAC addresses
Apply the clear mac-address-table bdomain command
Remove a mac security sticky configuration from an EVC interface
8 06:51:38.857: %REP-4-LINKSTATUS: GigabitEthernet0/0/1 (segment 10) is
8 06:51:39.096: %REP-4-LINKSTATUS: GigabitEthernet0/0/1 (segment 10) is
The router is sending traffic using the incremental MAC address table
Fast LSL is configured using a 200ms timer.
The router is configured with more than 2000 MAC addresses.
Configure REP with VLAN load balancing
Configure VPLS VFI on the VLANs
Chapter
OL-26630-08