Cisco ASR 903 Release Notes page 230

Caveats in Cisco IOS XE 3.9S Releases
–
Workaround: There is no workaround.
CSCud27333
•
Symptom: The router crashes continuously.
Conditions: Occurs when you issue an interface module reset (OIR) while the standby RSP is
booting.
Workaround: Do not issue an interface module reset (OIR) while the standby RSP is booting.
CSCud28982
•
Symptom: The router does not process egress CoS marking on an Ethernet service instance.
Conditions: Occurs when you configure QoS on an Ethernet service instance that is a member of a
bridge-domain and uses dot1q encapsulation.
Workaround: There is no workaround.
CSCud29479
•
Symptom: The router stops applying QoS configurations.
Conditions: Occurs under the following conditions:
–
–
–
–
Workaround: There is no workaround.
• CSCud30806
Symptoms: Policy with class map match-all with prec 1 and prec 2 is accepted for WRED.
Conditions: match-all should not accept 2 prec values class-map match-all prec1_2 match
precedence 1 match precedence 2
Workaround: N/A
CSCud33298
•
Symptom: The router crashes.
Conditions: Occurs when the peer device shuts down.
Workaround: There is no workaround.
CSCud33906
•
Symptom: Equal Cost Multipath (ECMP) loopback does not function properly.
Conditions: Occurs when a port-channel link dynamically assigned as an ECMP path.
Workaround: There is no workaround.
CSCud34346
•
Symptom: Nile manager crashes with the ECMP path when IPv4 scale is exceeded.
Conditions: This symptom occurs when scale is exceeded with the ECMP path.
Workaround: Do not allow the user to exceed the supported IPv4 route scale with ECMP.
CSCud34600
•
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
44
ONS-SI-155-I1
An Ethernet interface is configured with a single service instance
A QoS policy is attached to the service instance
The QoS policy contains a single class containing a match efp statement.
You reset the interface to the default configuration.
OL-26630-08