Cisco ASR 903 Release Notes page 219

Workaround: Use different timeslots, or make sure channel-group and cem-group numbers are
different under the same controller
• CSCua57325
Symptom: The router displays an OIR SPA error.
Conditions: Occurs under the following conditions:
–
–
–
–
–
CSCua61934
•
Symptoms: When policy-map with priority in class-default is attached to interface its not getting
rejected.
Conditions: Configure policy-map having priority in class-default. Attach the policy to interface
it's not getting rejected.
–
CSCua77688
•
Symptom: The router experiences remote CFM MEP flapping.
Conditions: Occurs when the router is connected via a CFM xconnect and the link is running a high
traffic rate.
Workaround: Reduce the rate of traffic.
CSCua90879
•
Symptom: QoS policies with a police statement on the class-default class do not take effect.
Conditions: Occurs when you apply a police statement to the class-default class within a QoS policy
on an ingress EVC interface.
Workaround: Apply the police statement to a static class, such as class cos0.
CSCub18160
•
Symptom: The router drops traffic on a link twice and displays a remote fault error message.
Conditions: Occurs when you issue an interface module reset (OIR) while the 10.000M XFP
(DWDM Edge performance) or XFP10GER-192IR-L XFPs are plugged into the ten Gigabit
Ethernet interface module and active.
Reloading the router also takes significantly longer when using these XFPs.
Workaround: There is no workaround.
CSCub26877
•
Symptoms: When Bridge-domain of the efp is changed and the new bridge-domain is not accepted,
the old bridge-domain gets rejected.
Conditions: EVC -BD configuration change.
Workaround: None
CSCub33576
•
Symptoms: All IMA interfaces does not come up until OIR of IM.
OL-26630-08
The router is running offloaded CFM sessions over an xconnect (pseudowire) interface.
The router is using a redundant hardware (dual RSP) configuration.
The remote router is using a non-redundant (single RSP) hardware configuration.
You reload the router.
Workaround: There is no workaround.
Workaround: None known at this time
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
Caveats in Cisco IOS XE 3.9S Releases
33